Rant: people keep swapping power supplies without checking the 5V rail under load
I've had 3 bench tickets in the past 2 weeks where a flaky drive or random reboot got blamed on the board when the 5V rail was sagging to 4.6V under load. Most guys just check voltage at idle with a multimeter and call it fine, but you need a load tester or at least watch it under a real workload in the BIOS. Anyone got a cheap way to stress the 5V rail without dragging out a full rig?
Ha, been there! Had a box last month that rebooted every few hours and sure enough the 5V was drooping to 4.7 under disk load, a plain stress loop in BIOS with a cheapo molex load got it to show up in minutes.