Tried the heat gun trick on a warped foam board mount and got a wavy mess
I read that warming up foam board helps flatten it, so I hit a 16x20 mount with my heat gun on low from about 8 inches away for maybe 20 seconds. Instead of flattening, the middle bubbled up and the edges curled worse than before, and now it won't sit flat in the frame at all. Turns out the foam core traps heat unevenly and the paper face shrinks at a different rate, which I did not know. I ended up cutting a fresh mount and pressing it under books for two days in my garage in Phoenix, and that worked fine. Has anyone found a heat method that actually works, or is pressing the only move here?