I finally watched a guy build a drawer box with a hammer and it made me put mine down
Stopped by a shop over in Akron last month to pick up some maple and the owner was showing a new kid how to fit a drawer box. He didn't touch a single clamp. Just set the box on the bench, gave the corner a couple taps with a 16 oz hammer, checked the square, and moved on. I stood there with my mouth open while he did all four corners in about 90 seconds. I asked him what the trick was and he said 'the wood tells you when it's home, you just have to listen to it.' I've been clamping and waiting 20 minutes per box for 11 years. Went back to my shop and tried his way on a scrap box and dang if it didn't sit dead square. Now I do the tap and check on every box before it gets glue, and I've cut my build time down a lot. Any of you tap your boxes into square, or am I the last one to hear about this?
Did you ever see that old Fine Woodworking piece where the guy talks about tapping joints home with a hammer instead of cranking down on clamps? I read it years ago and figured it was just old school talk, but hearing your story makes me think those guys were onto something real. Clamps can pull a box out of square just as easy as bring it in, so maybe the hammer and a quick check is the smarter move.