My 3D print failed 40 minutes into an 11 hour job because I skipped one dumb check
Last Tuesday I started printing a replacement knob for my drill press, and about 40 minutes in the filament snapped clean and the print turned into spaghetti. I had left the spool sitting out on the shelf for a month in my garage in Tucson, and the dry air plus dust made it brittle. I switched to a sealed bin with some desiccant packs and the next print ran the full 11 hours with no issues. Honestly if you are not storing your filament dry, you are just rolling dice every time. What are you all using to keep spools dry in a shop with no climate control?