Serious question, I quit using anti-seize on spark plugs and the threads came out cleaner
I know this goes against what most of us were taught, but I ran a little experiment on my own truck last spring and the results bugged me. Pulled all 8 plugs on a 2004 F-150 at 96k miles, and instead of the usual dab of anti-seize I just cleaned the threads with a wire brush and torqued them dry to spec. When I pulled them again about 14 months later, every one backed out smooth with zero galling and the torque reading on the breakaway was dead consistent across all 8. With the anti-seize I used to get this mushy feel and I was always second-guessing whether I was over-torquing because the stuff lubes the threads. My take is most of us are fighting a problem that only shows up on old cast iron heads, and on aluminum we are just inviting stripped threads. Now I run them dry with a drop of motor oil at most. What are you guys doing on aluminum heads, dry or are you still slapping paste on there?