Just realized I was putting dielectric grease on every cannon plug, and an old hand set me straight
Two years back I was working a King Air panel swap and slathering dielectric grease on every single cannon plug I touched because that's how I was taught. A guy with 30 years on the bench watched me for a minute and said "you're packing those like wheel bearings, cut it back to a thin film on the pins or you'll just trap junk in there." I brushed it off at first, but he pulled a plug I'd done 6 months before and the grease had gone gummy and grabbed a bunch of fuzz. Now I use a little dab on a toothpick, just enough to coat the pins, and I bag the rest of the connector dry. It takes longer per plug but pulling one apart clean 8 months later is worth it. What's your go-to amount, are you a thin film person or do you skip it on gold pins?