Used to solder every zone splice, now I'm using Wago levers on panel swaps
Back when I started doing panel swaps in Fort Worth, every zone wire got twisted, soldered, and taped, and a 16 zone job took me a solid 5 hours just on the can. Last week I did an 18 zone panel swap in about 2 hours using Wago 221 levers on the zone commons and it held up fine on the meter. Am I the only one who made the switch, or are some of you still soldering because you don't trust the levers long term?
Are you checking those levers again after a year or two in the heat? I've pulled apart plenty of taped and soldered splices that looked worse than a clean Wago, so I'm not sold on solder being the safer bet long term.