Debating torque stripe vs. witness mark on a 737 bleed valve job
Last week I was doing a bleed valve replacement on a 737 at our hangar in Wichita and I had to pick between a torque stripe or a plain witness mark for the final sign-off. Went with the torque stripe because our lead has been pushing them for a year and I figured it would make the next inspection faster, but now I'm second guessing it since the paint cracked on two of the bolts after a hot section run and it looks sloppy. The witness mark crowd says a sharpie line tells you way more about actual movement and takes ten seconds, while the stripe crew says it is a fast visual for anyone walking by and cuts down on missed fasteners during shift handoff. I get that stripes are only as good as how clean you prepped the surface, and honestly I rushed that part at the end of a 10 hour day. So what are you all running on engine accessory mounts, and has a cracked stripe ever caused you grief during a walk around? Real answers from guys who have done both would help. I am trying to settle this with the other mechs in my bay, not start a war.